Spindle Orientation Through Initiator With Marker M2501 - HEIDENHAIN TNC 415 Technical Manual

Spindle orientation through initiator with Marker M2501

The spindle can also be oriented through an initiator. This requires that Marker M2501 be set by the
PLC. This marker activates a spindle rotation at the speed defined in machine parameter MP3520.0
and in the direction of rotation defined in Marker M2656. If Marker M2501 is reset by the PLC (e.g.
through initiator), the spindle stops. The position value is shown in the status window. This method
can also be used to a enable a jog-mode spindle orientation.
MP3410.1 Spindle ramp slope for spindle orientation
Entry: 0.0000 to 1.9999 [V/ms]
MP3420 Positioning window for spindle
Entry: 0 to 65 535 [Increments]
1 Increment represents approx. 0.088 degrees
=
1024 lines
MP3430 Deviation of the reference mark from the desired position (spindle preset)
Entry: 0 to 360 [degrees]
MP3440 k -Factor for spindle orientation
v
Entry: 0.1 to 10 [
MP3440.0 k -Factor 1st gear range
v
MP3440.1 k -Factor 2nd gear range
v
MP3440.2 k -Factor 3rd gear range
v
MP3440.3 k -Factor 4th gear range
v
MP3440.4 k -Factor 5th gear range
v
MP3440.5 k -Factor 6th gear range
v
MP3440.6 k -Factor 7th gear range
v
MP3440.7 k -Factor 8th gear range
v
MP3520.0 Spindle speed activated by Marker M2501
Entry: 0.000 to 99 999.999 [rpm]
MP3520.1 Spindle speed for spindle orientation
Entry: 0 to 99 999.999 [rpm]
4-108 TNC 407/TNC 415/TNC 425
360 degrees
×
fourfold evaluation
1000°/min
]
°
4 Main Spindle 01.98