Hr 410 Portable Handwheel - HEIDENHAIN TNC 415 Technical Manual

10.4 HR 410 Portable Handwheel

MP7640 = 6
With MP7645.0 you define whether the keys on the handwheel are evaluated by the NC or the PLC.
MP7645.0 = 0
Keys are evaluated by NC
X
IV
Y
V
Z ACTUAL-
POSITION
CAPTURE
FEED RATE FEED RATE FEED RATE
SLOW MEDIUM FAST
– +
O109 O110 O111
I173 I174 I175
All keys except for the functions keys A, B, and
C, are evaluated by the NC. MP7670.x defines
the interpolation factor for the slow, medium
and fast settings. MP7671.x defines the speed
for the slow, medium and fast settings. The
speed is entered as a percentage of the manual
feed rate (MP1020.x).
Initializing parameters for handwheel
MP7645
When an HR 410 is installed, MP7645.0 has the following meaning:
Evaluation of HR 410 handwheel keypad
MP7645.0
Input: 0 =
1 =
MP7645.1 to MP7645.7 are without function
Interpolation factor for handwheel
MP7670
Input: 0 to 10
MP7670.0 Interpolation factor for low speed
MP7670.1 Interpolation factor for medium speed (only HR 410)
MP7670.2 Interpolation factor for high speed (only HR 410)
Manual feed rate in handwheel mode with HR 410
MP7671
Input: 0 to 1000 [% of MP1020]
MP7671.0 Low speed
MP7671.1 Medium speed
MP7671.2 High speed
01.98 TNC 407/TNC 415/TNC 425
Keys evaluated by NC
Keys evaluated by PLC
10 Electronic handwheel
MP7645.0 =1
Keys are evaluated by PLC
O96
I160
O98
I162
O100
I164
O104 O105
I168 I169
I171
O109 O110
I173 I174
All keys are evaluated by the PLC. Module
9036 sets the handwheel's axis and
interpolation. With W766 you can influence
the feed rate by pressing the direction keys.
O97
I161
O99
I163
O103
I167
O106
I170
I172
O111
I175
4-201