Touch Probe System Input; Connector Assignment X12 - HEIDENHAIN TNC 415 Technical Manual

8 Touch probe system input

The following 3D touch probe systems are available from HEIDENHAIN:
– TS 120 with cable transmission and integrated APE (interface electronics)
– TS 511 with infrared transmission of the trigger signal and connectable via APE (interface
electronics)
– TT 110 for workpiece measurement
– The TNC 415 and TNC 425 can also support the measuring touch probe system TM 110
For start-up and adjustment of the 3D-touch probe systems see Chapter "Machine Integration".
8.1 Connector assignment
X12 Touch probe system
D-subminiature female connector (15-pin)
Pin number Signal designation
1 Inner screen (0 V)
3 Ready/standby
4 Start
5 +15 V ± 10 % (U
6 + 5 V ± 5 % (U
7
Battery warning
8 0 V (U
9 Trigger signal
10 Trigger signal²
2, 11 to 15 Do not use
2 Stylus in rest position = signal high
3-36 TNC 407/TNC 415/TNC 425
X12
)
P
)
P
)
N
8 Touch probe system input 01.98