Edge Evaluation Of The Plc Inputs - HEIDENHAIN TNC 415 Technical Manual

MP4120.0 Preset value for counters C0 to C31
to MP4120.31 Entry range: 0 to 65 535 [PLC cycles]

2.5 Edge evaluation of the PLC inputs

The edge evaluation for the PLC inputs can be activated by marker M2497. An automatic edge
evaluation cannot be activated for the PLC inputs I192 to I254 on the second PLC I/O expansion
board.
Edge evaluation means that if the signal at the PLC input changes, a certain marker will be set for
the duration of a PLC run. If marker M2497 is set, the following markers will be set if the signals
change at the PLC inputs.
Marker for rising edges at the PLC inputs:
Marker
M1500 to M1531
M1564 to M1626
M1628 to M1652
Marker for falling edges at the PLC inputs:
Marker
M1700 to M1731
M1764 to M1826
M1828 to M1852
Marker Function
M2497 Activate the edge evaluation for PLC inputs
Rising-edge marker M1500 to M1652
Falling-edge marker M1700 to M1852
01.98 TNC 407/TNC 415/TNC 425
PLC inputs
I0 to I31
I64 to I126 (first extension board)
I128 to I152
PLC inputs
I0 to I31
I64 to I126 (first extension board)
I128 to I152
2 Program creation
Set Reset
PLC PLC
7-27