End Of Indexed Module Call (Endc) - HEIDENHAIN TNC 415 Technical Manual

End of Indexed Module Call (ENDC)

Abbreviation for PLC Editor:
Execution time [µs]
Number of bytes
Operands: none
Operation:
The ENDC command is used together with the CASE command. It must come directly after the list
of CM commands.
Structure of a CASE instruction:
Internal addressing (0 to 127 max.)
1 CASE B 150
2 CM 100 <-------
3 CM 200 <-------
4 CM 201 <-------
5 CM 202 <-------
6 CM 203 <-------
7 CM 204 <-------
8 CM 300 <-------
9 ENDC
Line 1: Command + Operand; the internal address of the required module must be filed in the
operand
Line 2: Call Module if operand content 0
Line 3: Call Module if operand content 1
Line 4: Call Module if operand content 2
Line 5: Call Module if operand content 3
Line 6: Call Module if operand content 4
Line 7: Call Module if operand content 5
Line 8: Call Module if operand content 6
Line 9: End of CASE instruction
7-130 TNC 407/TNC 415/TNC 425
ENDC (ENDCASE)
Byte Word
0
0
(0)
(1)
(2)
(3)
(4)
(5)
(6)
3 Commands
0
0
01.98