Setting Items By Use - Panasonic FP7 User Manual

5.3.2 Setting Items by Use

 Interrupt (INT0-INT7: Selectable by one point.)
Setting item
Function setting
 High-speed counter (HSC0-HSC3 / PLSC0-PLSC3: Selectable by channel.)
Setting item
Function setting
Elapsed value hold mode
Count mode
Counter elapsed value
Counter preset value
Counter upper/lower limit
values
 Comparison match output (CMP0-CMP7: Selectable by one comparison output.)
Setting item
Compare
Counter to be compared
Comparison output
function
Comparison value
Comparison output
destination
(Note): For setting the comparison match output, the high-speed counter, pulse output or positioning (H type only)
should be set.
REFERENCE
• For details of the interrupt function, refer to page 6-2.
• For details of the high-speed counter function, refer to page 7-2.
• For details of the comparison match output function, refer to page 8-2.
Settings
Unused / Comparison match output (when comparison values match) / Comparison
match output (OFF->ON) / (ON->OFF) / Comparison match output (OFF->ON) /
Comparison match output (ON->OFF) / Interrupt terminal input (OFF->ON) /
Interrupt terminal input (ON->OFF)
Settings
Unused / Direction distinction / Individual input /
Phase input (1 multiple) / Phase input (2 multiple) /
Phase input (4 multiple)
Switch on the checkbox for using this mode.
Ring / Linear
-2,147,483,648 to +2,147,483,647
-2,147,483,648 to +2,147,483,647
-2,147,483,648 to +2,147,483,647
Settings
Switch on the checkbox for comparing.
High-speed counter CH0/CH1/CH2/CH3
Pulse output PLS0/PLS1/PLS2/PLS3
Positioning (H type only) CH0/CH1/CH2/CH3
ON when elapsed value is smaller than setting value /
ON when elapsed value is larger than or equal to setting value
-2,147,483,648 to +2,147,483,647
External terminal / Internal I/O
Internal I/O
5.3 Application Setting
5-11