10.11 Repeat Operation
10.11.1
Overview of Repeat Operation
When the positioning table start contact is on, the unit repeats the operation set in the
positioning table.
Conditions of repeat control
Item
Repeat control is available
E-point control, P-point control + E-point
Operation pattern
control
C-point control + E-point control
Control method
Increment mode
Set the table of E-point control to 1 ms or
Dwell time setting
more.
Operation diagram (Setting operation on the table)
Operation diagram (Repeat operation)
10.11 Repeat Operation
Repeat control is unavailable
JOG operation, J-point control, Interpolation
control
Absolute mode
When setting 0 ms.
10-61