Operation Monitor Leds; Mode Setting Switches - Panasonic FP7 User Manual

2.1.2 Operation monitor LEDs

LED
1 Power supply of the unit
－
Input signal monitor (Note 1)
2 X0-XF
(Note 2)
3 Y0-YF Output signal monitor (Note 1)
Output polarity display
4 YN
(Note 3) (Note 4)
Output polarity display
5 YP
(Note 3) (Note 4)
Alarm/Error/Warning
6 ERR
occurrence display
(Note 1): The LEDs for the input and output both look as if they are continuously lit because the flashing speed is fast
when the frequencies of signals are high.
(Note 2): The LED of each input signal indicates the status after an input time constant processing.
(Note 3): The output polarity display is switched by the output polority setting using the tool software or a program.
(Note 4): When the output polarity is not set by the software or program, the both YN and YP turns off. Also, when the
settings of sink, source, push-pull (negative logic) or push-pull (positive logic) are mixed, the YN and YP turn on
according to the polarity, and a warning occurs simultaneously.

2.1.3 Mode setting switches

No. Description
1 ON: Use the interrupt function, OFF: Not use the interrupt function
2
3 Not available. They should be always OFF.
4
(Note): At the factory setting, the mode setting switch number 1 is set to "OFF" (the setting not to use the interrupt
function).
Description
2.1 Names and Functions of Parts
Color LED ON
Blue ON
Green Displays the status of the input signal.
Green Displays the status of the output signal.
Turns on when the output that is set to "Sink output"
Green
or "Push-pull output (negative logic)" exists.
Turns on when the output that is set to "Source
Green
output" or "Push-pull output (positive logic)" exists.
At the time of
Red alarm/error
occurrence
LED
LED OFF
Flashing
OFF
―
At the time of
In normal
warning
operation
occurrence
2-3