Input/Output Specifications and Wiring
2. Insert the wire without removing its insulation until it stops, and lightly grip the tool.
3. After press-fitting the wire, insert it into the housing.
4. When all wires have been inserted, fit the semi-cover into place.
KEY POINTS
Contact puller pin to redo wiring
•
If there is a wiring mistake or the wire is incorrectly pressure-connected,
use the contact puller pin provided with the fitting to remove the contact.
3-12
Press the houseing
against the pressure
connection tool so that
the contact puller pin
comes in contact with
this section.