Power On The Server For The First Time - Oracle SPARC T8-4 Installation Manual

Related Information
"Connect the SER MGT Cable" on page 59
■
"Configure the Preinstalled OS" on page 71
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 72
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 74
■

Power on the Server for the First Time

1.
At the terminal device, log in to the SP as root with a password of changeme.
XXXXXXXXXXXXXXXX login: root
Password: changeme (
displayed)
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->).
To enable first-time login and access to Oracle ILOM, a default Administrator account
Note -
and its password are provided with the system. To build a secure environment, you must change
the default password (
login to Oracle ILOM. If this default Administrator account has been changed, contact your
system administrator for an Oracle ILOM user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
By default, the SP is configured to use DHCP to obtain an IP address. If you plan
Note -
to assign a static IP address to the SP,
Port" on page 79
2. Power on the server using one of the following methods.
Press the power button.
■
At the Oracle ILOM prompt, type:
■
-> start /System
Are you sure you want to start /System (y/n)? y
The server initialization might take several minutes to complete.
nothing
) for the default Administrator account (root) after your initial
changeme
see"Assign a Static IP Address to the NET MGT
for more instructions.
Power on the Server for the First Time
Powering On the Server for the First Time 69