Ipv6 Multicast Forwarding Over Gre Tunnel Configuration Example - HP MSR ASM Configuration Manual

Task
Display IPv6 static multicast
MAC address entries.
Clear forwarding entries
from the IPv6 multicast
forwarding table.
Clear routing entries from
the IPv6 multicast routing
table.
IPv6 multicast forwarding over GRE tunnel
configuration example
This section provides an example of configuring IPv6 multicast forwarding over a GRE tunnel.
Network requirements
As shown in
Router B does not support IPv6 multicast. OSPFv3 is running on Router A, Router B, and Router C.
Configure a GRE tunnel so the receiver can receive the IPv6 multicast data from the source.
Figure 102 Network diagram
Configuration procedure
1. Enable IPv6 forwarding.
Command
display mac-address [ mac-address [ vlan vlan-id ]
| [ multicast ] [ vlan vlan-id ] [ count ] ] [ | { begin
| exclude | include } regular-expression ]
reset multicast ipv6 forwarding-table
{ { ipv6-source-address [ prefix-length ] |
ipv6-group-address [ prefix-length ] |
incoming-interface { interface-type
interface-number | register } } * | all }
reset multicast ipv6 routing-table
{ { ipv6-source-address [ prefix-length ] |
ipv6-group-address [ prefix-length ] |
incoming-interface { interface-type
interface-number | register } } * | all }
Figure 102, IPv6 multicast routing and IPv6 PIM-DM are enabled on Router A and Router C.
381
Remarks
Available in user view.
Available in user view.
When a forwarding entry
is removed from the IPv6
multicast forwarding
table, the corresponding
routing entry is also
removed from the IPv6
multicast routing table.
Available in user view.
When a routing entry is
removed from the IPv6
multicast routing table, the
corresponding
forwarding entry is also
removed from the IPv6
multicast forwarding
table.