Figure 36 Oui Filter; Table 15 Oui Filter - ZyXEL Communications MSC1000G User Manual

Ies-5000 series management switch card

Hide thumbs Also See for MSC1000G:

Table of Contents

Figure 36 OUI Filter

The following table describes the labels in this screen.

Chapter 5 Access Control List Screens

Use the drop-down list boxes to select an DSL port on a line card for which you wish

to configure packet type filtering.

Click Load to display the port's current settings.

Select Enable to activate this filter.

Clear this check box to disable the filter without deleting it.

Specify the action on matched frames.

Select accept to allow frames with a matched OUI field in the MAC addresses. The

switch blocks frames with other OUIs not specified.

Select deny to block frames with a matched OUI field in the MAC addresses. The

switch allows frames with other OUIs not specified.

Enter the first three octets of a MAC address in the format xx:xx:xx. For example,

Click Apply to save the changes in this screen to the system's volatile memory. The

system loses these changes if it is turned off or loses power, so use the Config Save

on the navigation panel and then the Save button to save your changes to the non-

volatile memory when you are done configuring.

Click Cancel to begin configuring the screen again.

MSC1000G User's Guide