MSC1000G User's Guide
ras> show arp
ip address
--------------- ----- ----------------- ----------
172.23.14.26
172.23.14.76
172.23.14.91
172.23.14.98
172.23.15.97
172.23.15.172
172.23.15.254
arp entry: 7
27.3.3 show atm Command
Syntax:
show atm <slot-port>|<slot-port-vpi/vci> [reset]
This command displays ATM traffic counters. It can also reset the counters.
The following example displays the ATM traffic counters for DSL port 5 on the line card in
slot 7.
ras> show atm 7-5
port 7-5
rx cells
tx cells
rx rate
tx rate
crc errors
The following table describes labels in this example.
Table 144 show atm Command Display
LABEL
rx cells
tx cells
rx rate
tx rate
crc errors
since pvc
create
since last
reset
434
time ether address
290 00:0d:60:cc:14:e9 outband
290 00:00:e8:97:70:64 outband
290 00:0a:e4:0a:76:21 outband
290 00:50:70:ff:f3:89 outband
300 08:00:46:74:0e:a5 outband
300 02:0e:a6:89:41:60 outband
300 00:04:80:9b:78:00 outband
since pvc create
-------------------- --------------------
:
:
(byte/s):
(byte/s):
:
DESCRIPTION
This field shows the number of ATM cells received on this port.
This field shows the number of ATM cells transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of Cyclic Redundancy Check errors on this port.
This column displays the ATM traffic statistics that have accumulated from when
the PVC was created (either via command or the building of the DSL link).
This column displays the ATM traffic statistics that have accumulated from the
most recent time that the counters were reset.
interface
since last reset
0
0
0
0
0
Chapter 27 show Commands
0
0
0
0
0