Table 130 Acl Commands - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
Table 130 acl Commands (continued)
COMMAND
dhcpsnoop
dot1x
292
server active <vid>
<1|2>
set <vid>
<serverip1>
[serverip2]
delete <vid>
[serverip]
set <vid>
show
disable <slot-port>
enable <slot-port>
flush <slot-port>
pool delete <slot-
port> <ip>
set <slot-port>
<ip>
show <slot>|<slot-
port>
disable
enable
DESCRIPTION
Sets the active DHCP server to
which the DHCP requests are sent
first.
<vid>
= a VLAN ID to be served
with DHCP relay.
1 = Sets the first DHCP server as
the active server.
2 = Sets the second DHCP server
as the active server.
1
The default is .
Sets an entry for forwarding
DHCP requests to the DHCP
servers at the specified IP
addresses. <vid> = a VLAN ID
to be served with DHCP relay.
Removes an entry for forwarding
DHCP requests to the DHCP
server at the specified IP address.
Creates an option82 entry for the
VLAN.
Displays DHCP relay and
option82 settings.
DHCP snooping allows the system
to identify and block packets from
devices using unknown/static IP
addresses.
Deactivates DHCP snooping on
the specified subscriber port(s).
Activates DHCP snooping on the
specified subscriber port(s).
Clears the DHCP snooping table
on the specified port(s).
Removes the static IP address
from the DHCP snooping table.
Adds a static IP address to the
DHCP snooping table. You can
add up to 3 static IP addresses
per port.
Displays the DHCP snooping table
on the specified port.
IEEE 802.1X authentication.
Turns off IEEE 802.1X.
Turns on IEEE 802.1X.
Chapter 17 acl Commands
P
M
M
M
M
L
M
M
M
M
M
L
M
M