ZyXEL Communications MSC1000G User Manual page 404

MSC1000G User's Guide
where
<rule>
<action>
404
= The rule that classifies traffic flows. Ordering of the criteria is
important. The system first compares the layer 2 fields first, the
layer 3 fields and then the protocol type.
The following lists the set of criteria you can configure.
• ether <etype> vlan <vid>
• ether <etype> srcmac <mac>
• ether <etype> dstmac <mac>
• vlan < vid > srcmac <mac>
• vlan < vid > dstmac <mac>
srcmac < mac > dstmac <mac>
•
• vlan < vid > pri <priority>
• ether <etype>
• vlan <vid>
• srcmac <mac>
• dstmac <mac>
• pri <priority>
protocol <protocol>
•
• [srcip <ip>/<mask>[stip <ip>/<mask>[tos
<tos>[srcport <port>[dstport <port>]]]]]
where
• ethper <etype>
• vlan <vid> = VLAN ID (1~4094).
srmac <mac>
• = Source MAC address.
• drmac <mac> = Destination MAC address.
• priority < priority
• protocol < protocol
igmp , ip , gre , icmp
dstip <ip>/<mask>
•
mask.
• srcip <ip>/<mask>
tos <stos> <etos>
•
between 0 and 255.
• dstport <sport> <eport>
srcport <sport> <eport>
•
= The action(s) to perform on the classified packets. The
following lists the actions you can set.
rate <rate
• > = Sets the transmission rate (1~65535 in kbps) for
the matched traffic.
• rvlan <rvlan>
(1~4094).
• rpri <rpri>|deny
~7) of the matched packets or drops (
= Ethernet type (0~65535
> = Priority (0 ~ 7)
> = Protocol type: tcp
or user specified.
= Destination IP address and subnet
= Source IP address and subnet mask.
= Sets the ToS (Type of Service) range
= Destination port range.
= Source port range.
= Replaces the VLAN ID with this VLAN ID
= Replaces the priority with this priority (0
deny ) the packets.
Chapter 26 profile Commands
).
, udp , ospf ,