Port Adsl Pmm Disable Command; Port Adsl Pmm Enable Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
This command masks (turns off) attributes for the specified port(s). It is for advanced
troubleshooting. Use an entry with a "1" instead of "0" before the "x" in order to turn the
attribute back on (remove the option mask).
The following example sets ADSL port 5 on the line card in slot 7 to not use Trellis encoding.
ras> port adsl optionmask 7-5 0x0001

25.3.12 port adsl pmm disable Command

Syntax:
port adsl pmm disable <slot-port>
This command turns off the Power ManageMent (PMM) feature on the specified ADSL2/2+
port(s).
The following example sets ADSL2+ port 5 on the line card in slot 7 to not use power
management.
ras> port adsl pmm disable 7-5

25.3.13 port adsl pmm enable Command

Syntax:
port adsl pmm enable <slot-port> [L2|L3]
370
Bit swapping allows the system to respond to noise on a tone by
sending it's data on another tone. The subscriber (ATU-R)
equipment must also support this in order for it to work.
= disable 1-bit constellation
0x0010
1-bit constellation allows the system to send individual bits over
DMT tones that can only support one bit. This allows the connection
to use as many of the tones as possible.
= disable transmit windowing (ADSL2+ only)
0x0020
= disable s=0.5 support option in G.dmt.
0x0040
0.5 support maps two Reed-Solomon codewords into one data frame
(instead of one) to increase the maximum G.dmt transmission rate.
= disable G.lite rate limit (G.lite only).
0x0080
Disabling the G.lite rate limit allows the G.lite upstream transmission
rate to be greater than 512 Kbps.
Chapter 25 port Commands