Table 137 Lcman Commands; Table 138 Lcman Show Command - ZyXEL Communications MSC1000G User Manual

The following example shows an overview of all of the cards that are installed in the system's
slots.
ras> lcman show
id state card type
-- -------- ----------- ------------- ------------------- ---------------------
1 -
2 active MSC1000G
3 -
4 active ALC1248G-51
5 active SLC1248G-22
The following table describes labels in the example.

Table 138 lcman show Command

LABEL
ID
state
card type
uptime
f/w version
heat
vol
mon
down
out
Chapter 23 lcman Commands
uptime f/w version
3:17:42:09 V3.50(LU.0)b3
01:25 V3.50(ABD.0)b3
3:17:40:28 V3.50(ABF.0)b3
DESCRIPTION
This is the slot number.
This displays whether or not the installed card is turned on.
This identifies the model of card that is installed or was last installed in the
slot.
This is how long the card has been active.
This is the release of firmware that the card is using.
The following columns display a "V" if an alarm has been detected. "-"
displays if no related alarm has been detected.
This displays whether or not there is an alarm due to the card's temperature
being too high or too low.
This displays whether or not there is an alarm due to the card's voltage being
too high or too low.
This displays whether or not the hardware monitor sensor has failed.
This displays whether or not the installed card is down (inactive).
This displays whether the card is installed or has been removed.
MSC1000G User's Guide
heat vol mon down out
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -
341