Common Command Notation; Command Privilege Levels; Table 115 Common Command Notation - ZyXEL Communications MSC1000G User Manual

16.4 Common Command Notation

The following table describes commonly used command parameter notation.

Table 115 Common Command Notation

NOTATION
[...]
|
sub1
sub2
up1
up2
<giga-port>
<index>
<ip>
<mac>
</netmask>
<port>
<slot>
<slot-port>
<vid>
<vpi/vci>

16.5 Command Privilege Levels

There is a high, medium or low privilege level for each command.
High privilege commands are only available to administrators with high privilege access. High
privilege commands include things like creating administrator accounts, restarting the system
and resetting the factory defaults. Administrators with high privilege access can use all
commands including the lower privilege commands.
Chapter 16 Commands
DESCRIPTION
The optional fields in a command are enclosed in square brackets [], for instance,
ping <ip> [<count>]
The | symbol means "or".
This represents subtending port 1. On the MSC's front panel this is SFP slot 1.
This represents subtending port 2. On the MSC's front panel this is SFP slot 2.
This represents uplink port 1. On the MSC's front panel this is Gigabit interface 3 (a
Gigabit Ethernet port/SFP slot pair).
This represents uplink port 2. On the MSC's front panel this is Gigabit interface 4 (a
Gigabit Ethernet port/SFP slot pair).
This represents the Gigabit Ethernet uplink port(s) or subtending port(s) or both.
This is an integer that sets the index number of a table entry. The range starts at 1.
The end of the range varies by command.
This represents a valid IP version four address in dotted decimal notation.
192.168.1.1 is an example.
This represents a MAC address in "a0:c5:12:34:56:78" format.
This represents the bit number of the subnet mask of an IP address. The range is 0
to 32.
To find the bit number, convert the subnet mask to binary and add all of the 1's
together. Take "255.255.255.0" for example. 255 converts to eight 1's in binary.
There are three 255's, so add three eights together and you get the bit number (24).
This represents the UDP or TCP port number of a service.
This represents the number of an individual chassis slot where a DSL line card is
located.
This represents the number of an individual chassis slot where a DSL line card is
located and the number of a DSL port(s). You can specify a single port <1>, all ports
<*> or a list of ports <1,3,4>. You can also include a range of ports <1,5,6~10,11,12>.
This represents a VLAN identifier (VLAN ID). The range is [1..4094].
The VPI (Virtual Path Indicator) and VCI (Virtual Channel Indicator) of an individual
PVC (Permanent Virtual Circuit). The VPI setting can be 0 to 255. The VCI setting
can be 32 to 65535 if the VPI is 0 or 1 to 65535 if the VPI is not 0.
means that the count field is optional.
MSC1000G User's Guide
ip
257