Alarm Port Show Command - ZyXEL Communications MSC1000G User Manual

where
<fac>
<target>
This command sets the alarm severity threshold for recording alarms on an individual port(s).
The system reports an alarm on a port if the alarm has a severity equal to or higher than the
port's threshold.
The following example has the systems only record critical alarms on DSL port 7 on the line
card in slot 4.
ras> alarm port set 4-7 critical

18.3.7 alarm port show Command

Syntax:
alarm port show <slot>
where
<fac>
<target>
This command displays port alarm severity level thresholds. The system reports an alarm on a
port if the alarm has a severity equal to or higher than the port's threshold.
Chapter 18 alarm Commands
= The log facility (
local1
messages to different files in the syslog server. See your syslog
program's documentation for details.
=
snmp|syslog|all|none
device is to send (SNMP, syslog or all).
this alarm category.
= The log facility (
local1~local7
messages to different files in the syslog server. See your syslog
program's documentation for details.
=
snmp|syslog|all|none
device is to send (SNMP, syslog or all).
this alarm category.
MSC1000G User's Guide
~ ) that has the device log the syslog
local7
The type of alarm messages that the
none
disables alarm reports on
) that has the device log the syslog
The type of alarm messages that the
none disables alarm reports on
321