Switch Port Show Command - ZyXEL Communications MSC1000G User Manual

This command sets the Port VLAN ID assigned to untagged frames or priority frames (0 VID)
received on this port(s).
The following example sets the PVID of the subtending 1 Gigabit Ethernet interface to 76.
ras> switch port pvid sub1 76

28.9.12 switch port show Command

Syntax:
switch port show
This command displays the settings for the MSC's Gigabit Ethernet interfaces. An example is
shown next.
ras> switch port show
port
---- --------------- ---- ---- ------ ---- ---- ---- ---- ----- ----
sub1 Subtend1
sub2 Subtend2
up1 Uplink1
up2 Uplink2
ras>
28.9.13 switch port speed Command
Syntax:
switch port speed <giga-port> <speed>
where
<giga-port>
<speed>
This command sets the port speed and duplex of a 1000BaseT uplink port(s).
Chapter 28 switch Commands
name en mode speed
V sub
V sub
V up
V up
= This represents 1000BaseT uplink ports. The port speed is fixed
for subtending ports and/or SFP slots that use a fiber-optic
interface. Use
tup|all
= The port's speed and duplex mode.
Use
auto|1000F|100F|100H
Auto or 1000 (Mbps) or 100 (Mbps) is to match the port speed
of the WAN switch to which this port is to connect.
F is for full duplex communications or H for half duplex
communications.
fc pvid prio gvrp ftype
auto - 1 0
auto - 1 0
auto - 1 0
auto - 1 0
f trunking is not enabled. Use
up1|up2|all i
if trunking is enabled.
.
MSC1000G User's Guide
vt
- all -
- all -
- all -
- all -
481