Switch Dot3Ad Show Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

28.5.6 switch dot3ad show Command

Syntax:
switch dot3ad show sub|up
where
sub
up
This command displays the link aggregation state of the specified ports. It displays the settings
for both the subtending and uplink ports if you do not specify one or the other.
This example displays the MSC's link aggregation state on the subtending and uplink ports.
ras> switch dot3ad show
agg enable
--- ------ ------
sub V
up -
ras>
"V" displays for ports that have link aggregation enabled "-" displays for ports that do not.
28.6 switch garptimer Commands
Use the
switch garptimer
28.6.1 switch garptimer show Command
Syntax:
switch garptimer show
This command displays the MSC's GARP timer settings, including the join, leave and leave-
all timers. An example is shown next.
ras> switch garptimer show
join time
leave time
leaveall time (ms): 10000
ras>
466
= The subtending ports
= The uplink ports.
type
static
static
commands to configure GARP timeout periods.
(ms): 200
(ms): 600
Chapter 28 switch Commands