Shdsl Port Setup Advanced; Figure 88 Shdsl Port Setup: Advanced; Table 54 Shdsl Port Setup: Advanced - ZyXEL Communications MSC1000G User Manual

Table 53 SHDSL Port Setup: Line Card (continued)
LABEL
SHDSL Profile
Select

10.9.2 SHDSL Port Setup Advanced

Click Port > SHDSL in the navigation panel to open the SHDSL Port Setup screen. Click the
Setup button to open the following screen. Use this screen to configure an SHDSL port's
detailed settings.

Figure 88 SHDSL Port Setup: Advanced

The following table describes the fields in this screen.

Table 54 SHDSL Port Setup: Advanced

LABEL
UP
Apply
Cancel
Enable
SHDSL Profile
Chapter 10 DSL Port Setup Screens
DESCRIPTION
Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal to
noise ratio settings) to assign to this port. Use the SHDSL Profile screen to
configure SHDSL port profiles.
Note: You must apply the same profile on the two SHDSL ports
connecting to the same subscriber device.
Use the Select column to choose a DSL port from which you want to copy settings.
DESCRIPTION
Click this to return to the previous screen.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Select this check box to turn on this port.
Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal to
noise ratio settings) to assign to this port. Use the SHDSL Profile screen to
configure SHDSL port profiles.
MSC1000G User's Guide
147