Igmp Filter Setup Slot Screen; Figure 66 Copy; Figure 67 Igmp Filter Setup: Slot - ZyXEL Communications MSC1000G User Manual

Table 35 IGMP Filter Setup (continued)
LABEL
Copy
ID
State
Card Type
Up Time
Firmware

9.4.1 IGMP Filter Setup Slot Screen

Click Multicast > IGMP > Filter Setup and then the slot number of an active line card to
open the following screen.

Figure 67 IGMP Filter Setup: Slot

Chapter 9 IGMP Screens
DESCRIPTION
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the
number of the DSL port from which you want to copy IGMP filter profile settings.
2. Click Copy to open the following screen.

Figure 66 Copy

3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy
the IGMP filter profile setting. Click Select All to mark all of the port check boxes or
click Select None to clear all of the port check boxes.
5. Click Apply to copy the IGMP filter settings to all of the ports that you have
selected in this screen. Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an active
line card to go to a screen where you can copy a DSL port's IGMP filter profile setting
to another DSL port.
This field displays whether a line card is active or not.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
MSC1000G User's Guide
119