The following example sets the MSC to block Telnet sessions.
ras> sys server disable telnet
29.3.29 sys server enable Command
Syntax:
sys server enable telnet|ftp|web|snmp|ssh
This command turns on access for a service on the MSC.
The following example sets the MSC to allow Telnet sessions.
ras> sys server enable telnet
29.3.30 sys server show Command
Syntax:
sys server show
This command displays the MSC's service access control settings. The following is an
example.
ras> sys server show
server status
------ ------ -----
telnet
ftp
web
icmp
snmp
ssh
ras>
29.4 sys snmp Commands
Use these commands to configure the MSC's SNMP settings.
29.4.1 sys snmp getcommunity Command
Syntax:
sys snmp getcommunity <community>
Chapter 29 sys Commands
port
V
23
V
21
V
80
V
-
V
161
V
22
MSC1000G User's Guide
503