Figure 90 Copy - ZyXEL Communications MSC1000G User Manual

Table 55 PVC Setup (continued)
LABEL
Copy
Delete
VPI / VCI
PVID
Profile
MUX
Priority
Apply
Cancel
ID
State
Card Type
Up Time
Firmware
Chapter 10 DSL Port Setup Screens
DESCRIPTION
Do the following to copy VLAN and PVC settings from one DSL port to another DSL port
or ports.
1. Use the Select column to choose a PVC which you want to copy to another port.
2. Click Copy to open the following screen.

Figure 90 Copy

3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy
the settings. Click Select All to mark all of the port check boxes or click Select None
to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Delete to remove the selected PVC.
Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on this port.
Type a PVID (Port VLAN ID) to assign to untagged frames received on this channel.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring must also be set to the fixed status in the VLAN.
Use the drop-down list box to select an ATM profile to assign to this channel.
Select the encapsulation type (llc or vc) for this channel.
Type the priority value (0 to 7) to add to incoming frames without a (IEEE 802.1p) priority
tag.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save on
the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This column lists the slot numbers of the line cards. Click the ID number of an active DSL
line card to go to a screen where you can view and delete PVCs from the line card's DSL
ports.
This field displays whether a line card is active or not.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
MSC1000G User's Guide
151