MSC1000G User's Guide
21.2.4 diagnostic selt show Command
Syntax:
diagnostic selt show <slot>|<slot-port>
This command displays the Single End Loop Test (SELT) result after you have performed a
SELT test on the specified port on the line card. The report tells you what gauge of telephone
wire is connected to the port and the approximate length of the line measured both in meters
(m) and thousands of feet (Kft).
21.2.5 diagnostic selt test Command
Syntax:
diagnostic selt test <slot-port>
This command starts the Single End Loop Test (SELT) on the specified port on the line card.
This test checks the distance to the subscriber's location.
Note: The port must have an open loop. There cannot be a DSL device, phone, fax
machine or other device connected to the subscriber's end of the telephone
line.
332
Chapter 21 diagnostic Commands