Packet Filter Slot Screen; Figure 39 Packet Filter: Slot - ZyXEL Communications MSC1000G User Manual

Table 17 Packet Filter (continued)
LABEL
Apply
Cancel
Copy
ID
State
Card Type
Up Time
Firmware

5.8 Packet Filter Slot Screen

Click the slot number of a line card in the Packet Filter screen to display the screen shown
next.

Figure 39 Packet Filter: Slot

Chapter 5 Access Control List Screens
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy the settings you configure above to another port or ports.
1. Click Copy.
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
This is the slot number of a line card. Click the index number of an active line card to
display the Packet Filter Slot screen where you can view and copy settings from one
port to another port or ports on the selected line card.
This field displays whether a line card is active or not.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
MSC1000G User's Guide
89