Figure 135 Switch Setup; Table 96 Switch Setup - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide

Figure 135 Switch Setup

The following table describes the labels in this screen.

Table 96 Switch Setup

LABEL
GARP Timer:
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using
GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all
registrations. GARP timers set declaration timeout values.
Refer to Chapter 15 on page 249
Join Timer
Leave Timer
Leave All Timer
Port Isolation
218
DESCRIPTION
for more background information.
Join Timer sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is between 100
and 65535 milliseconds; the default is 200 milliseconds. See the chapter on VLAN
setup for more background information.
Leave Timer sets the duration of the Leave Period timer for GVRP in milliseconds.
Each port has a single Leave Period timer. Leave Time must be two times larger
than Join Timer; the default is 600 milliseconds.
Leave All Timer sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All Timer must
be larger than Leave Timer; the default is 1000 milliseconds.
Turn on port isolation to block communications between subscriber ports. When
you enable port isolation you do not need to configure the VLAN to isolate
subscribers.
Chapter 13 Switch Screens