Figure 147 Switch Port Setup; Table 102 Switch Port Setup - ZyXEL Communications MSC1000G User Manual

Figure 147 Switch Port Setup

The following table describes the labels in this screen.

Table 102 Switch Port Setup

LABEL
Apply
Cancel
Port
Enable
Name
Mode
Chapter 13 Switch Screens
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This is the label of a Gigabit Ethernet interface.
Select this check box to turn on an interface. The factory default for all ports is
enabled. A port must be enabled for data transmission to occur.
Enter a descriptive name that identifies this port. You can use up to 31 ASCII
characters; spaces are not allowed.
Set a port as subtending to daisy-chain other Ethernet switches. Use uplink mode
to connect to a backbone Ethernet switch or router.
MSC1000G User's Guide
233