Acl Dhcpsnoop Show Command - ZyXEL Communications MSC1000G User Manual

This command removes a static IP address from the DHCP snooping table of a port on the
specified line card. The following example removes the static IP address of 192.168.1.11 from
the port 10 on the line card in slot 2.
ras> acl dhcpsnoop pool delete 2-10 192.168.1.11
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10 -
ras>

17.3.6 acl dhcpsnoop show Command

Syntax:
acl dhcpsnoop show <slot>|<slot-port>
Use this command to display the current static DHCP snooping settings of the port(s) on the
line card. The following example displays the settings of port 10 on the line card in slot 2.
ras> acl dhcpsnoop show 2-10
port enable static ip pool
----- ------ -----------------------------------------------
2-10 -
ras>
17.4 acl dot1x Commands
Use these commands to configure the IEEE 802.1x authentication feature.
17.4.1 acl dot1x disable Command
Syntax:
acl dot1x disable
This command turns off the IEEE 802.1X authentication feature.
17.4.2 acl dot1x enable Command
Syntax:
acl dot1x enable
This command turns on the IEEE 802.1X authentication feature.
Chapter 17 acl Commands
192.168.1.10
192.168.1.10 192.168.1.11
MSC1000G User's Guide
301