Port Shdsl Commands - ZyXEL Communications MSC1000G User Manual

The following example adds the PVC on DSL port 5 on the line card in slot 7 with VPI 8 and
VCI 35 to VLAN 23.
ras> port pvc vlan 7-5-8/35 23 join untag

25.11 port shdsl Commands

Use the
port shdsl
25.11.1 port shdsl alarmprof Command
Syntax:
port shdsl alarmprof <slot-port> span|stuc|stur|* <alarmprofile>
where
span|stuc|stur|*
<alarmprofile>
This command sets the specified SHDSL port(s) or end point(s) to use an alarm profile.
The following example sets SHDSL port 8 on the line card in slot 6 to use the SESalarm alarm
profile at both the STU-C and the STU-R.
ras> port shdsl alarmprof 6-8 * SESalarm
25.11.2 port shdsl pbo Command
Syntax:
port shdsl pbo <slot-port> normal_epl|forced_epl|forced_no_epl <value>
Chapter 25 port Commands
commands to configure the subscriber SHDSL ports.
= = set alarm profile for the whole span This is the entire
span
connection including any SHDSL regenerators that might be
located between the STU-C (SHDSL Termination Unit -
Central) and STU-R (SHDSL Termination Unit - Remote) end
points. An SHDSL regenerator amplifies the SHDSL signal in
order to increase the connection distance.
= set alarm profile at STU-C (SHDSL Termination Unit -
stuc
Central) end point
= set alarm profile at STU-R (SHDSL Termination Unit -
stur
Remote) end point
= set alarm profile at both STU-C and STU-R
*
= The name of an SHDSL alarm profile.
MSC1000G User's Guide
385