ZyXEL Communications MSC1000G User Manual page 270

MSC1000G User's Guide
Table 124 port Commands (continued)
COMMAND
optionmask
pmm
power
270
<slot-port>
<option_mask>
disable <slot-port> Turns off power management mode.
enable <slot-port>
[L2|L3]
param <slot-port>
[l0time <l0time>]
[l2time <l2time>]
[l2pcb <l2atpr>
<l2atprt>] [l2rate
<l2minrate>
<l2maxrate>
<l2threshold>]
<slot-port>
fix|power|rate
<max_us_tx>
<max_ds_tx>
<max_rx>
DESCRIPTION
Sets the following attributes.
0x0001 = disable Trellis
0x0002 = disable Reed-Solomon
0x0004 = disable upstream bitswap
0x0008 = disable downstream bitswap
0x0010 = disable 1-bit constellation
0x0020 = disable transmit windowing
(ADSL2+ only)
0x0040 = disable s=0.5 support (G.dmt
only)
0x0080
= disable G.lite rate limit (G.lite
only)
Turns on power management mode.
L2 = power management mode L2
L3 = power management mode L2 and L3
Sets the L0 (full power) and L2 (low power)
power mode transition settings.
<l0time> = Time (10 ~ 65535 seconds)
to stay in L0 mode.
<l2time> = Time (10 ~ 65535 seconds)
to wait before performing another power
trims in L2 mode.
<l2atpr>
= Maximum aggregated power
reduction (APTR) per trim in dB (0 ~
l2atprt ).
<l2atprt>
= Maximum total aggregate
power reduction in dB (0-15).
<l2minrate> = Minimum rate in L2 (32
~ 4096).
<l2maxrate> = Maximum rate in L2
(minimum L2 rate ~ maximum upstream
rate in kbps).
<l2threshold> = Line rate threshold to
stay in L2 mode. When the rate is not within
the threshold, the port switches to L0 mode
immediately.
Specifies the maximum allowed transmit
power and maximum aggregate received
power.
fix|power|rate = PSD and power
adaptivity
fix = fixed mode
power = priority to power
rate
= priority to rate
<max_us_tx> = maximum upstream
transmit power, -130~200 in 0.1 dBm.
<max_ds_tx> = maximum downstream
transmit power, -50~200 in 0.1 dBm.
<max_rx> = maximum aggregate receive
power at atu-c, -255~255 in 0.1 dBm.
Chapter 16 Commands
P
M
M
M
M
M