Sys User Commands - ZyXEL Communications MSC1000G User Manual

29.6 sys user Commands

Use these commands to configure the MSC's administrator account and authentication
settings.
29.6.1 sys user auth Command
Syntax:
sys user auth <mode>
where
<mode>
This command sets which database the MSC uses to authenticate a user.
The following example sets the MSC to check a user's username and password against the
local database.
ras> sys user auth 1
29.6.2 sys user server Command
Syntax:
sys user server <ip> <port> <secret> [high|middle|low|deny]
where
<ip>
<port>
Chapter 29 sys Commands
= Sets which database the switch uses to authenticate a user.
= local
1
= radius
2
= local first and then radius
3
= The IP address of the RADIUS server.
= The RADIUS server's listening port number.
The MSC uses the default of 1812 if you do not specify a port.
MSC1000G User's Guide
509