25.6 port enable Command
Syntax:
port enable <slot-port>
This command turns on the specified subscriber port(s).
The following example turns on DSL port 5 on the line card in slot 7.
ras> port enable 7-5
25.7 port name Command
Syntax:
port show <slot-port> <name>
where
<name>
This command sets a name for the specified subscriber port(s).
The following example sets DSL port 5 on the line card in slot 7 to use the name Bob.
ras> port name 7-5 bob
25.8 PPPoA to PPPoE (PAE) Translation
Before migrating to an Ethernet infrastructure, a broadband network might consist of PPPoA
connections between the CPE devices and the DSLAM and PPPoE connections from the
DSLAM to the BRAS (Broadband Remote Access Server). The following figure shows a
network example.
Figure 158 Mixed PPPoA-to-PPPoE Broadband Network Example
Chapter 25 port Commands
=
A name to identify the subscriber port.
PPPoA
MSC1000G User's Guide
BRAS
PPPoE
375