Profile Alarmvdsl Delete Command - ZyXEL Communications MSC1000G User Manual

MSC1000G User's Guide
<sesl>
<uasl>
<iru>
<ift>
The
alarmprofile set
an alarm trap and generates a syslog entry when the thresholds of the alarm profile are
exceeded.
Configure
alarmvdsl
use them with specific VDSL ports.
The following example sets an alarm profile named SESalarm that has the MSC send an alarm
trap and generate a syslog whenever the connection (from the IES-5000 to the subscriber) has
more than 3 severely errored seconds within a 15-minute period.
ras> profile alarmvdsl set SESalarm sesl 3

26.7.3 profile alarmvdsl delete Command

Syntax:
profile alarmvdsl delete <profile>
where
<profile>
This command allows you to delete an individual VDSL alarm profile by its name. You cannot
delete the DEFVAL alarm profile.
The following example deletes the SESalarm alarm profile.
ras> profile alarmvdsl delete SESalarm
416
= The number of Severely Errored Seconds (0~900) that are
permitted to occur within 15 minutes.
= The number of UnAvailable Seconds (0~900) that are permitted
to occur within 15 minutes.
= A rate in kilobits per second (Kbps). If an interleave mode
connection's upstream transmission rate increases by more than
this number, then a trap is sent.
= "1" sets the profile to trigger an alarm for an initialization
failure trap. "0" sets the profile to not trigger an alarm for an
initialization failure trap.
command configures VDSL port alarm thresholds. The MSC sends
profiles first and then use the
= The name of an alarm profile.
port vdsl alarmprof
Chapter 26 profile Commands
command to