Changing the channel
References
SINUMERIK Operate Commissioning Manual
Channel switchover via touch operation
On the HT 8 and when using a touch screen operator panel, you can switch to the next channel
or display the channel menu via touch operation in the status display.
4.4
Settings for the machine
4.4.1
Switching over the coordinate system (MCS/WCS)
The coordinates in the actual value display are relative to either the machine coordinate system
or the workpiece coordinate system.
By default, the workpiece coordinate system is set as a reference for the actual value
display.
The machine coordinate system (MCS), in contrast to the workpiece coordinate system (WCS),
does not take into account any zero offsets, tool offsets and coordinate rotation.
Procedure
Milling
Operating Manual, 05/2017, A5E40868956
Press the <CHANNEL> key.
The channel changes over to the next channel.
- OR -
If the channel menu is available, a softkey bar is displayed. The active
channel is highlighted.
Another channel can be selected by pressing one of the other softkeys.
1.
Select the "Machine" operating area.
2.
Press the <JOG> or <AUTO> key.
Setting up the machine
4.4 Settings for the machine
73