Editing The Simulation Display; Blank Display - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining

7.6 Editing the simulation display

Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
7.6 Editing the simulation display
7.6.1

Blank display

You have the option of replacing the blank defined in the program or to define a blank for
programs in which a blank definition cannot be inserted.
Note
The unmachined part can only be entered if simulation or simultaneous recording is in the
reset state.
Procedure
242
- OR -
Press the "From left" softkey if you wish to view the workpiece from the
left.
- OR -
Press the "From right" softkey if you wish to view the workpiece from the
right.
1. The simulation or the simultaneous recording is started.
2. Press the ">>" and "Blank" softkeys.
The "Blank Input" windows opens and displays the pre-assigned values.
3. Enter the desired values for the dimensions.
4. Press the "Accept" softkey to confirm your entries. The newly defined
workpiece is displayed.
Operating Manual, 05/2017, A5E40868956
Milling