Parameter Reset To Factory Settings - Siemens SINAMICS S120 Operating Instructions Manual

3.5

Parameter reset to factory settings

The factory settings represent the defined original status of the device on delivery.
Resetting the parameters to the factory settings means that all the parameter settings made
since the system was delivered are reset.
Resetting Parameters via AOP30
Note
When the parameters have been reset to the factory settings, initial commissioning needs to
be carried out.
Cabinet Modules Operator Panel AOP30
Operating Instructions, 04/2014, A5E03263551A
Set parameter filter to "Parameter reset":
<MENU> <Commissioning/Service> <Device commissioning>
<OK> <30: Parameter Reset> <OK>
Reset all parameters to factory settings:
Factory settings for all the device parameters are restored.
Commissioning
3.5 Parameter reset to factory settings
33