Siemens SINUMERIK 840D sl Operating Manual page 399

● Edge finishing
Edge finishing is performed in the same way as finishing, except that the last infeed (finish
base) is omitted.
● Chamfering
Chamfering involves edge breaking at the upper edge of the longitudinal slot.
Figure 10-6
Note
The following error messages can occur when chamfering inside contours:
● Safety clearance in the program header too large
● Immersion depth too large
● Tool diameter too large
Procedure
Milling
Operating Manual, 05/2017, A5E40868956
Geometries when chamfering inside contours
This error message appears when chamfering would, in principle, be possible with the
parameters entered for FS and ZFS, but the safety clearance then could not be
maintained.
This error message appears when chamfering would be possible through the reduction
of the immersion depth ZFS.
This error message appears when the tool would already damage the edges during
insertion. In this case, the chamfer FS must be reduced.
1. The part program or ShopMill program to be processed has been created
and you are in the editor.
2. Press the "Milling" softkey.
3. Press the "Groove" and "Longitudinal groove" softkeys.
The "Longitudinal Groove (SLOT1)" input window opens.
Programming technological functions (cycles)
10.2 Milling
399