Siemens SINUMERIK 840D sl Operating Manual page 463

G code program parameters
PL Machining plane
SC Safety clearance
F Feedrate
Parameter
TC
Retraction
(for ShopMill program)
ZR
(for ShopMill program)
Align tool through beta and gamma angles
β
(for ShopMill program)
γ
(for ShopMill program)
Directly position rotary axes
B1
(for ShopMill program)
C1
(for ShopMill program)
Milling
Operating Manual, 05/2017, A5E40868956
mm
*
Description
Name of the swivel data set
Note: The selection box only appears if more than one swivel data set has been set
up.
No The axis is not retracted before swiveling
Retraction in the direction of machine axis Z
Retract towards the machine axis Z and then in the direction X, Y
Maximum retraction (up to the software end position) in the tool direction
Incremental retraction (specified retraction distance, up to the software
end position) in the tool direction
When retracting in the tool direction, in the swiveled machine state, several axes
can move (travel).
Retraction path - only for incremental retraction in the tool direction
Align tool with swivel axes
● Input value
The required angle can be freely entered
● β = 0°
● β = 90°
● 0°
● 180°
● The required angle can be freely entered
Directly align tool with swivel axes:
The required angle can be freely entered
The required angle can be freely entered
Programming technological functions (cycles)
10.4 Turning - milling/turning machine
ShopMill program parameters
T
D Cutting edge number
F Feedrate
S / V Spindle speed or constant cutting rate rpm
mm/min
mm/rev
m/min
Unit
Degrees
Degrees
Degrees
Degrees
463