Siemens SINUMERIK 840D sl Operating Manual page 678

Tool management
13.16 Working with Multitool
If a multitool is reactivated, on which tools with monitoring are mounted, then the lifetime/unit
quantity for all tools on the multitool are set to the setpoint no matter whether the tools are
disabled or not.
Preconditions
In order to be able to reactivate a tool, the monitoring function must be activated and a setpoint
must be stored.
Procedure
Reactivating and positioning
When the "Reactivate with positioning" function is configured, then also the magazine location
at which the selected multitool is located is positioned at the loading point. You can exchange
the multitool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring types
set in the NC for a tool are reset during reactivation.
References
SINUMERIK Operate Commissioning Manual
678
1. Select the "Parameter" operating area.
2. Press the "Tool wear" softkey.
3. Position the cursor at the multitool that is disabled and which you
would like to reactivate.
- OR -
Position the cursor on the tool that you want to reactivate again.
4. Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or
workpiece count.
The tool and the multitool are then no longer disabled (the disable
is withdrawn).
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Operating Manual, 05/2017, A5E40868956
Milling