Entering The Search Target Via Search Pointer - Siemens SINUMERIK 840D sl Operating Manual

6.7.5

Entering the search target via search pointer

Enter the program point which you would like to proceed to in the "Search Pointer" window.
Requirement
The program is selected and the controller is in the reset state.
Screen form
Each line represents one program level. The actual number of levels in the program depends
on the nesting depth of the program.
Level 1 always corresponds to the main program and all other levels correspond to
subprograms.
You must enter the target in the line of the window corresponding to the program level in which
the target is located.
For example, if the target is located in the subprogram called directly from the main program,
you must enter the target in program level 2.
The specified target must always be unambiguous. This means, for example, that if the
subprogram is called in the main program in two different places, you must also specify a target
in program level 1 (main program).
Milling
Operating Manual, 05/2017, A5E40868956
3. If the "Higher level" and "Lower level" softkeys are available, use these
to change the program level.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into account.
The search screen closes.
The current block will be displayed in the "Program" window as soon as
the target is found.
5. Press the <CYCLE START> key twice.
The execution will continue from the interruption point.
Software option
You require the "Extended operator functions" option for the "Search pointer"
function (only for 828D).
Machining the workpiece
6.7 Starting machining at a specific point
169