Simulating machining
7.8 Changing and adapting a simulation graphic
Note
Selected section
The selected sections and size changes are kept as long as the program is selected.
7.8.2
Panning a graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
7.8.3
Rotating the graphical representation
In the 3D view you can rotate the position of the workpiece to view it from all sides.
Requirement
The simulation or simultaneous recording has been started and the 3D view is selected.
Procedure
246
1.
Press a cursor key if you wish to move the graphic up, down, left, or right.
1.
Press the "Details" softkey.
2.
Press the "Rotate view" softkey.
Operating Manual, 05/2017, A5E40868956
Milling