Siemens SINUMERIK 840D sl Operating Manual page 32

Introduction
2.2 Operator panel fronts
32
<Plus>
● Opens a directory which contains the element.
● Increases the size of the graphic view for simulation and traces.
<Minus>
● Closes a directory which contains the element.
● Reduces the size of the graphic view for simulation and traces.
<Equals>
Opens the calculator in the entry fields.
<Asterisk>
Opens a directory with all of the subdirectories.
<Tilde>
Changes the sign of a number between plus and minus.
<INSERT>
● Opens an editing window in the insert mode. Pressing the key
again, exits the window and the entries are undone.
● Opens a selection box and shows the selection possibilities.
● In the machining step program, enters an empty line for G code.
● Changes into the double editor or into the multi-channel view from
the edit mode into the operating mode. You can return to the edit
mode by pressing the key again.
+ <INSERT> + <SHIFT>
For G code programming, for a cycle call activates or deactivates
the edit mode.
<INPUT>
● Completes input of a value in the entry field.
● Opens a directory or a program.
● Inserts an empty program block if the cursor is positioned at the
end of a program block.
● Inserts a character to select a new line and the program block is
split up into two parts.
● In the G code, inserts a new line after the program block.
● In the machining step program, inserts a new line for G code e
● Changes into the double editor or into the multi-channel view from
the edit mode into the operating mode. You can return to the edit
mode by pressing the key again.
<ALARM> - only OP 010 and OP 010C
Calls the "Diagnosis" operating area.
<PROGRAM> - only OP 010 and OP 010C
Calls the "Program Manager" operating area.
<OFFSET> - only OP 010 and OP 010C
Calls the "Parameter" operating area.
Operating Manual, 05/2017, A5E40868956
Milling