Default Settings For Manual Mode - Siemens SINUMERIK 840D sl Operating Manual

Parameter
Machining
direction
X0
Z0
X1
Z1
FS1...FS3 or R1...R3
XF2
D
UX
UZ
5.9

Default settings for manual mode

Specify the configurations for the manual mode in the "Settings for manual operation" window.
Default settings
Settings
Type of feedrate
Setup feedrate G94
Setup feedrate G95
Variable increment
Spindle speed
Milling
Operating Manual, 05/2017, A5E40868956
Description
● Face
● Longitudinal
Reference point ∅ (abs)
Reference point (abs)
End point X ∅ (abs) or end point X in relation to X0 (inc)
End point Z (abs) or end point Z in relation to X0 (inc)
Chamfer width (FS1...FS3) or rounding radius (R1...R3)
Undercut (alternative to FS2 or R2)
Infeed depth (inc) – (for roughing only)
Final machining allowance in X direction (inc) – (for roughing only)
Final machining allowance in Z direction (inc) – (for roughing only)
Meaning
Here, you select the type of feedrate.
● G94: Axis feedrate/linear feedrate
● G95: Revolutional feedrate
Enter the desired feedrate in mm/min.
Enter the desired feedrate in mm/rev.
For variable increments, enter the desired increment when traversing axes.
Here, enter the desired spindle speed in rpm.
Execution in manual mode
5.9 Default settings for manual mode
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
155