Contour Call (Cycle62) - Only For G Code Program - Siemens SINUMERIK 840D sl Operating Manual

Programming technological functions (cycles)
10.3 Contour milling
Procedure for deleting a contour element
10.3.6

Contour call (CYCLE62) - only for G code program

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
The contour is in the calling main program.
2. Labels
The contour is in the calling main program and is limited by the labels that have been
entered.
3. Subprogram
The contour is located in a subprogram in the same workpiece.
4. Labels in the subprogram
The contour is in a subprogram and is limited by the labels that have been entered.
Procedure
438
3. Position the cursor at the position where a contour element is to be in‐
serted or changed.
4. Select the desired contour element with the cursor.
5. Enter the parameters in the input screen or delete the element and select
a new element.
6. Press the "Accept" softkey.
The desired contour element is inserted in the contour or changed.
1. Open the part program or ShopMill program to be executed.
2. Position the cursor on the contour element that you want to delete.
3. Press the "Delete element" softkey.
4. Press the "Delete" softkey.
1. The subprogram to be edited has been created and you are in the editor.
2. Press the "Contour milling" softkey.
Operating Manual, 05/2017, A5E40868956
Milling