Selection Of The Cycles Via Softkey - Siemens SINUMERIK 840D sl Operating Manual

Parameter Description
● Cuboid
X0
Y0
X1
Y1
ZA
ZI
● Polygon
N
SW
L
● Without
HA Initial dimension
HI Final dimension (abs) or final dimension in relation to HA (inc)
PL Machining plane
● G17 (XY)
● G18 (ZX)
● G19 (YZ)
RP Retraction plane (abs)
SC Safety clearance (inc)
Acts in relation to the reference point. The direction in which the safety clearance is effec‐
tive is automatically determined by the cycle.
Machining Milling direction
direction
● Down-cut
● Up-cut
Retraction position Lift mode before new infeed
pattern
● To RP
● Optimized
9.15

Selection of the cycles via softkey

Overview of machining steps
The following machining steps are available for insertion.
Milling
Operating Manual, 05/2017, A5E40868956
1st corner point X
1st corner point Y
2nd corner point X (abs) or 2nd corner point X referred to X0 (inc)
2nd corner point X (abs) or 2nd corner point X referred to X0 (inc)
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Number of edges
Width across flats
Edge length
No blank use
Creating a ShopMill program
9.15 Selection of the cycles via softkey
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
295