Machining the workpiece
6.15 Mold making view
Requirements
● The required program is opened in the mold making view.
● The "Graphic" softkey is active.
Procedure
6.15.5
Searching for program blocks
Using the "Search" function, you can go specifically to program blocks where you can edit
programs. You can find and replace text in one step.
Precondition
● The required program is opened in the mold making view.
● The "NC blocks" softkey is active.
Procedure
See also
Searching in programs (Page 177)
Replacing program text (Page 179)
222
1.
Press the ">>" and "Select point" softkeys.
Cross-hairs for selecting a point are shown in the diagram.
2.
Using the cursor keys, move the cross-hairs to the desired position in the
graphic.
3.
Press the "Select NC block" softkey.
The cursor jumps to the associated program block in the editor.
1.
Press the "Search" softkey.
A new vertical softkey bar appears.
Operating Manual, 05/2017, A5E40868956
Milling