Siemens SINUMERIK 840D sl Operating Manual page 130

Setting up the machine
4.11 Handwheel assignment
Procedure
Deactivate handwheel
130
1. Select the "Machine" operating area.
2. Press the <JOG>, <AUTO> or <MDI> key.
3. Press the menu forward key and the "Handwheel" softkey.
The "Handwheel" window appears.
A field for axis assignment will be offered for every connected handwheel.
4. Position the cursor in the field next to the handwheel with which you wish
to assign the axis (e.g. No. 1).
5. Press the corresponding softkey to select the desired axis (e.g. "X").
- OR
Open the "Axis" selection box using the <INSERT> key, navigate to the
desired axis, and press the <INPUT> key.
Selecting an axis also activates the handwheel (e.g., "X" is assigned to
handwheel no. 1 and is activated immediately).
6. Press the "Handwheel" softkey again.
- OR -
Press the "Back" softkey.
The "Handwheel" window closes.
1. Position the cursor on the handwheel whose assignment you wish to
cancel (e.g. No. 1).
2. Press the softkey for the assigned axis again (e.g. "X").
- OR -
Open the "Axis" selection box using the <INSERT> key, navigate to the
empty field, and press the <INPUT> key.
Clearing an axis selection also clears the handwheel selection (e.g., "X"
is cleared for handwheel no. 1 and is no longer active).
Operating Manual, 05/2017, A5E40868956
Milling