Turning - Milling/Turning Machine; General; Stock Removal (Cycle951) - Siemens SINUMERIK 840D sl Operating Manual

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Maximum depth infeed

Lift mode before new infeed

If the machining operation requires several points of insertion, the retraction height to

which the tool is retracted, is selected as follows:

● To retraction plane

● Z0 + safety clearance

If there are no elements larger than Z0 in the pocket area, "Z0 + safety clearance" can

be selected as the lift mode.

Turning - milling/turning machine

In all turning cycles apart from contour turning (CYCLE95), in the combined roughing and

finishing mode, when finishing it is possible to reduce the feedrate as a percentage.

You can use the "Stock removal" cycle for longitudinal or transverse stock removal of corners

at outer or inner contours.

Removing stock from corners

For this cycle, the safety clearance is additionally limited using setting data. The lower value

is taken for machining.

Please refer to the machine manufacturer's specifications.

Operating Manual, 05/2017, A5E40868956

Machine manufacturer

Please also refer to the machine manufacturer's specifications.

Programming technological functions (cycles)

10.4 Turning - milling/turning machine

Sinumerik 840de sl Sinumerik 828d